• 3-6 Volt DC Motor with triple winding "never stuck" coils.
• 1:48 ratio gearbox with dual output shafts - can be used with 1 or 2 wheels.
• Wired 2-pin 0.1" socket power connector.
• Two 60mm (2.35") plastic wheels with grippy rubber treads provided.
• 3AA Battery Box with Switch and reliable breadboard pins.
• Two of each Male-to-Female 100cm and 10cm ZipWires.

The M1W2-KIT has everything needed to get a motor turning in minutes. It pairs the M1W2 geared DC motor and its two grippy wheels with a PW-3AA battery box and ZipWire leads, so you can wire the motor to the battery directly or run it through your own breadboard circuit.

The motor runs on 3 to 6 Volts, and the PW-3AA supplies 4.5 Volts from three AA cells with a built-in on/off switch. A 1:48 gearbox drives two output shafts for one or two wheels. Male-to-female ZipWires in 10cm and 100cm lengths let you build on the bench or run power out to a moving model. Add a push-button or a transistor switch from a Junior Genius kit to control it.